Publicidad
Idiomas disponibles
Idiomas disponibles
RFID Tag Mounting - Windshield
The diagrams below show suitable mounting locations of windshield RFID tags. Choose a tag mounting location that meets your local vehicle code and is at
least 2.5" (6.4 cm) from any materials containing metal. This includes the vehicle roof line, side pillars and rearview mirror mounting block. Make sure that
the tag is not behind any metallic surface or darkened trim around the window. For LMHNTG, hang from rearview mirror.
Minimum 2.5" (6.4cm)
Rearview Mirror
Clearance
Minimum 2.5" (6.4cm)
Clearance
Interior Windshield Mounting Locations and Clearances
LMUNTG Dual-Purpose Vehicle RFID Tag
Windshield Installation
Step 1 - Make sure that the intended mounting surface is clean and free of
any contaminants.
Step 2 - Transfer the tag to the location on the vehicle that you have
determined suitable for your application.
NOTE: Handle the tag with care during installation. Do not excessively bend
or distort the tag when removing it from the liner.
Step 3 - Smooth out the tag to ensure complete adhesion and remove any
air pockets. It is best to apply the tag by the edges as shown in the picture
to the right.
NOTE: Once the tag has been mounted, do not attempt to remove the tag.
This will damage the tag and tag will become inoperable.
NOTE: Care should be given when mounting tags onto windows or
headlamp lenses containing conductive coatings or embedded radio
antennas. These are often found on high-end vehicles. These can reduce
range or block RFID from working altogether.
Minimum 2" (5cm)
Minimum 2.5" (6.4cm)
Clearance
Clearance
Minimum 2.5" (6.4cm)
Clearance
Minimum 2.5" (6.4cm)
Rearview Mirror
Clearance
Minimum 2" (5cm)
Wiper Clearance
Optional Exterior Windshield Tag Mounting Locations and Clearances
Minimum 2" (5cm)
Minimum 2.5" (6.4cm)
Clearance
Clearance
Minimum 2" (5cm)
Wiper Clearance
Publicidad
