Publicidad
Idiomas disponibles
Idiomas disponibles
GB
GB
Manual operation
Manual operation
Controls and indicators see fig. D
Permanent change to manual operation: depress the
for about 5
seconds until the respective LED lights up. The actuator is now
D
permanently in the manual operation mode. Control via the EIB is
disabled.
A short press on the
key selects the outputs to be switched. If
only one LED flashes, the output is parametrized for switching.
2 flashing LEDs indicate the shutter function.
=
>
Keys 1/
and 0/
can be used for switching the output indicated by
a flashing LED A1 – A16, the switching state itself being indicated
by the LED beside the keys. The switching state of the non selected
outputs is indicated, as for bus operation, by LEDs A1 –A16.
To quit the manual mode: depress the
key for about 5 seconds
until the respective LED goes out.
Publicidad
