DeWalt DW412 1/4 Manual De Instrucciones página 7

382957/DW412 5/8/02 9:10 AM
Switch
To turn the unit on, depress the side of the dust protected
switch that corresponds to the symbol "I". To turn the tool off,
depress the side of the switch that corresponds to the symbol
"O". See Figure 4.
Paper Punch
A paper punch is provided with your sander to let you
perforate regular sandpaper to make dust collection possible.
To perforate your sandpaper, install the sandpaper on the tool
as instructed in this manual. With the sander turned off and
unplugged, place the paper punch on the paper so that the
tabs at the edges of the punch are against any two adjacent
sides of the sanding pad, as shown in Figure 5. Press the
punch against the pad so that the 8 points penetrate the paper,
as shown in Figure 6. (Press the punch into the pad as far as
it will go.) Remove the paper punch and the paper is ready.
An alternate method of perforating the paper is to fasten the
punch down to a suitable work surface and press the sander
(with the paper attached) down on the punch. Two holes are
provided in the punch for this purpose. Use #8 flat head
screws.
Page 4
4
FIG. 1 FIG. 2
LIMITING
RIBS
FIG. 3
CLAMP LEVER
SANDING
PAD
ABRASIVE
PAPER