Cleaning The Scale; Calibrating The Scale; Troubleshooting - Etekcity EB9380H Manual De Usuario

EN

Cleaning the Scale

1. Use a slightly damp cloth to clean the surface
of the scale, followed by a soft, dry cloth to wipe
away the remaining moisture.
2. Do not use chemical or abrasive cleaning agents
to clean the scale.
14

Calibrating the Scale

If the scale has been moved or flipped upside down,
it must be calibrated to ensure accurate results.
1. Place the scale on a hard, flat surface.
2. Step on the scale with one foot until the display
lights up, then step off.
3. The scale will show " ", indicating that the
calibration was successful.

Troubleshooting

Problem
Open the battery compartment cover and remove the plastic strip.
Scale does not turn on. Replace the batteries (see page 13).
Insert batteries under the correct polarity as marked in the battery compartment.
Display backlight does not
come on when stepping on Scale may be malfunctioning. Contact
the scale.
Display shows " ". Weight exceeds 180 kg / 400 lb. Use another scale with a higher weight range.
Replace the batteries (see page 13).
Display shows " ".
Scale needs to be calibrated. Step off the scale, wait for the display to show "
Display shows " ".
then step back on the scale.
Place scale on a level surface.
Reading is inaccurate.
Step off the scale, wait for the display to show "
Remove the batteries for 45 seconds and replace them to reset the scale.
If your problem is not listed, please contact Customer Support
Possible Solution
Customer Support (see page 17).
",
", then step back on the scale.
.
(see page 17)
EN
15