Troubleshooting - Uline NewAir Flex H-7259 Manual Del Usuario

NO POWER TO THE SYSTEM
PROBLEM
There is no power to the
system and the control
panel display is OFF.
DISPLAYED FAULT MESSAGES
DISPLAYED MESSAGE
#01 E-Stop Pressed
#03 Clamp Open
#17 Check Film Path
#07 Edge Seal Fault
PROBLEMS WITH MAKING INFLATED MATERIAL
PROBLEM
The material will not advance –
the control panel is on.
The material advances and
edge seals are present, but
the material does not fill
with air.
PAGE 8 OF 30

TROUBLESHOOTING

CAUSES
System is off.
Main power cord is unplugged at
the outlet.
Facility power supply is interrupted.
Electrical component failure.
CAUSES
E-Stop switch pressed.
Edge seal clamp is open.
Out of film.
Material roll is improperly loaded.
Edge seal wheel is missing or not
fully seated.
Edge seal failure.
CAUSES
Material roll is empty.
Material roll is improperly loaded.
Electrical or mechanical failure.
Material roll improperly loaded.
The material layers are not properly
wrapped around the inflation nozzle.
Faulty material.
Electrical or mechanical failure.
RECOMMENDATIONS
Turn the main power switch to the on
position.
Verify the main power cord is plugged
into a properly rated outlet – see Electrical
Power Requirements on page 2.
Verify facility power supply – see Electrical
Power Requirements on page 2.
Contact Uline Customer Service at 1-800-
295-5510.
RECOMMENDATIONS
Twist E-Stop to release.
Hinge the clamp handle up to close the
edge seal and press reset key.
Load new roll.
Reload roll as required.
Check condition of edge seal and verify
that it is fully seated.
Replace as required – see Replacing the
Edge Seal on page 7.
Contact Uline Customer Service.
RECOMMENDATIONS
Load a new roll as required – See Loading
Material Roll on page 4.
Reload roll as required – See Loading
Material Roll on page 4.
Contact Uline Customer Service.
Verify that the open end of the material is
facing in towards the inflation nozzle.
Load new material – See Loading Material
Roll on page 4.
Return material roll – contact Uline
Customer Service.
Contact Uline Customer Service.
0521 IH-7259