Use Instruction - Vaporesso Target MINI II Kit Manual Del Usuario

USE INSTRUCTION:

1) Filling the E-juice and install tank.
Uncrew the drip tip directly, then you can fill your favorite
E-juice through the opening.and following below to replace
coil or galss.
1 Filling E-Juice 2 Replace coil 3 Replace glass
2 English
2) Main screen
Mode
battery level
Setting value
coil
Instant Voltage/
resistance
wattage
value
Last vaping duration
puff counter
3) Lock and unlock button:
• Continually 5 press of fire to turn on and off
• Continually 3 press of fire to unlock/lock.
• Continually 3 press of mode to lock/unlock mode
button.
4) Choose your mode
• VW-H /VW-N /VW-S (Variable Wattage mode - high/normal/soft): it will automatically select the adequate
average wattage for your atomizer If you switch between different ohms resistance.
• CCW (Custom Curve of Wattage mode): To use the up and down buttons to customize you own curve of wattage
output line ,move to the next bar with a quick press of the fire button,press the mode button to save and exit
when setting is done.
• SP (Super Player mode): In this mode, it will support broader resistance range from 0.03Ω to 5Ω, which is
adaptive to mainstream RDA tanks.
• VV(Variable Voltage mode): You can manualy adjust the voltage to match the resistances of the coil you use, the
higher resistance of the coil you use, the higher voltage it require correspondingly.
• CCV (Custom Curve of Voltage mode): In this mode, you can use the up and down buttons to customize you own
curve of voltage line ,move on to the next bar with a quick press of the fire button , press the mode button to save
and exit when all modifications are done.
• SS/NI/TI : Variable temperature control mode for Stainless Steel/Nickel/Titanium material (Auto Function
enabled). the device can separately support Nickel 200, Titanium, and Stainless Steel coils smartly , it will
intelligently adjust temperature control parameters based on the heating wire material's resistance value you use,
also it allows you to change the startup wattage.
• M1/M2 (Temperature Coefficient of Resistance) You can choose your own manual setting and set the TCR at
English 3