GYS NOMAD POWER PRO 45 Manual De Instrucciones página 9

2
3
4
5
60"
6
7
If the engine does not start after doing the above steps, it means that the vehicle's battery could be
drained excessively (excessively discharged to less than 1V). Or a reverse connection. Please review the
following steps:
60"
6b
7
CHARGING MOBILE PHONES
not supplied
NOMAD POWER PRO 45
Connect the booster cable plug into the booster cable socket.
1- Connect the red clamp to the (+) of the battery.
2- Connect the black clamp to the (-) of the battery.
Double check the connection. If the booster cable clamps are cross-connected on the
vehicle's battery, please correct them immediately.
Reverse connection will cause damage and explosion.
Press the power button (1) for 5 seconds. All four LED indicators will be illuminated
successively.
Then, the LED indicator will show the level of battery status. It must be green light to
work with jump start function, if the capacity is low it may fail to jump start battery.
Press the Jump start button (2), all the LED indicators will be flash simultaneously
(If the LEDs are not flashing, see step 6b below)
The jump start function will be activated. Please start the engine within 60 seconds
(the jump start function will switch off automatically within 60 seconds).
When the engine has been started successfully, please press the power button (1) for
5 seconds to switch off the jump starter. Remove the booster cable clamps from the
vehicle's terminal.
If the booster clamps are connected to the correct polarity, but LED indicators are not
flashing. The voltage of vehicle's battery might be too low, so the base unit could not
identify the polarity. Please press and hold the Jump start button (2) for 5 seconds to
activate the jump start function FORCIBLY.
When all the LED indicators are flashing, please start the engine within 60 seconds.
The jump function will be shut down automatically after 60 seconds.
When the engine has been started successfully, please press the power button (1) for
5 seconds to switch off the jump starter. Remove the booster cable clamps from the
vehicle's terminal.
Connect the USB plug (not supplied) to the USB socket and press the power
button (1) to activate the unit to start charging your electronic device (mobile
or tablet).
.
EN
9