Connection Diagram - Blaupunkt 600 Serie Manual De Instrucciones

Connections:
•
REVERSE: reverse signal from car, needed to
Connections:
enable reverse camera
•
REVERSE: reverse signal from car, needed to
•
P.ANT: Switched power supply for active
enable reverse camera
antenna (12V/ max. 200mA)
•
P.ANT: Switched power supply for active
•
ACC: Ignition signal
antenna (12V/ max. 200mA)
•
P.CONT: Switched power supply for external
•
ACC: Ignition signal
amplifier (12V/ max. 200mA)
•
P.CONT: Switched power supply for external
•
ILLUMI: car lights input, needed for dimmer
amplifier (12V/ max. 200mA)
•
ILLUMI: car lights input, needed for dimmer
cause flickering display!
•
PARKING: Connect to handbrake signal
cause flickering display!
•
WHEEL KEY: SWC input (steering wheel control)
•
PARKING: Connect to handbrake signal
•
WHEEL KEY: SWC input (steering wheel control)

Connection Diagram

Connection Diagram
Connections:
•
B+ : Power output (enabled if ACC is ON) (12V/
Connections:
max. 500 mA)
•
B+ : Power output (enabled if ACC is ON) (12V/
•
CAMERA 12V: Power supply for camera
max. 500 mA)
(enabled if source camera active) (12V/ max.
•
CAMERA 12V: Power supply for camera
200mA)
(enabled if source camera active) (12V/ max.
•
DAB phantom feeding (12V/ max. 100mA)
200mA)
•
DAB phantom feeding (12V/ max. 100mA)
Note:
For operation, ACC must be connected and switched
Note:
on. Device is not operable without ACC.
For operation, ACC must be connected and switched
on. Device is not operable without ACC.
cause high battery drain.
To keep all settings and memory, BATTERY must be
cause high battery drain.
connected permanently.
To keep all settings and memory, BATTERY must be
connected permanently.
45