Before Connecting - MBO TG 1000 Instrucciones Para El Servicio

TG 1000 GB 26.02.2003
Use of heater
element
See "Table-Top
Barbecue Description"
illustration.
Before
connecting
Warning:
Never start to use
barbecue without
water in reflector.
Cooking
Barbecue
Grill
Handle
position 3
position 2
position 1
in the barbecue
tray recess
9:05 Uhr Seite 3
All manuals and user guides at all-guides.com
START-UP
First, please remove all packing material from the barbecue.
Then insert the heater element as follows:
The thermostat housing must be fitted into the provided recess
in the barbecue tray, and the heater element must be at an
angle of approximately 20º in relation to the upper surface of
the barbecue tray. The thermostat housing can now be slid
onto the edges of the barbecue tray. Now slowly lower the
heater element, whereby the two ends of the lateral wire
beneath the heater element must enter the holes in the barbe-
cue tray.
Place barbecue on a solid, level surface. Before connecting
equipment to power supply, place reflector in tray and fill up to
maximum mark with water, so that aluminium reflector is
covered with water. The water level must never drop below the
minimum mark. To make the reflector easier to clean later it
may be covered with aluminium foil. If the water evaporates
too quickly during cooking, top water up accordingly in order
to prevent tray from overheating. However, never pour water
directly onto heating spiral, since this would become damaged.
Now move cooking grill to required height in position 1, 2 or 3
by hooking cooking grill into opening in barbecue tray using
the four studs beneath the handles.
3
www.MBOservice.net