Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARE THE HOOD
®
ALLURE
TM
QS1 SERIES
RANGE HOOD
Page 4
CONNECT
WIRING
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3 ¼"x 10"
Vertical & for 7"Round
Discharge)
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7"Round
Discharge)
_ib
WARNING: To reduce the risk of electric shock,
make sure power is switched
off at the service
panel. Lock or tag service panel to prevent power
from being switched
on accidentally.
HOUSE
WIRING
(120 VAC)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3 _" x 10"
Horizontal Discharge)
El
Remove appropriate
Duct Knockout(s)
from
or back of
top
hood.
UPTO 1"
SIDE-TO-SIDE
ADJUSTMENT
TOP/BACK
TAPE
EDGE
PIVOT
DAM PER/DUCT
CONNECTOR
(Vertical discharge
position shown)
31_'' x 10" Ducted
Discharge
Only: Attach Damper/Duct
Connector
over knockout opening. Make sure damper Pivot
is nearest to Top/Back
Edg#_ of hood. Remove _
from
damper flap.
7" Round Ducted Discharge Only: Re-install 7" Round Duct
Plate removed in Step #1 under "PREPARE THE HOOD"
section.
Install a 7" round damper (purchase
separately).
Damper flap must open freely in direction of air flow (away
from range hood).
To accomodate
off-center ductwork
the Damper/Duct
Connector can be installed up to 1-inch on either side of
hood center or the 7" Round Duct Plate can be installed
up to Y2" on either side of hood center. In extreme off-center
installations, one end of the duct connector may need to be trimmed
to clear the electrical cable clamp.
CARDBOARD
to protect
cooktop)
[_
Connect House
to hood. Use
of
Wiring (120 VAC)
a
piece
Cardboard
to protect the cooktop, if necessary.
El
Connect house black to hood black wire, house white to hood
white wire, and house ground under Green Ground Screw.
Securely tighten cable clamp onto house wiring.
GREEN
GROUND
SCREW
[_
Replace wiring cover.

Publicidad

loading