Publicidad
Idiomas disponibles
Idiomas disponibles
iNSTALL HOOD
®
ALLURE
TM
QS1 SERIES
RANGE HOOD
Page
5
NON-DUCTED
FILTERS
If hood is to be installed Non-Ducted:
Purchase a set of (2) non-ducted filters from your local distributor or
retailer and attach them to the aluminum mesh filters.
KEYHOLE
(4)
MOUNTING
SCREW
(4)
[_
Hang
(4) Mounting
(from parts bag).
hood from
Screws
Slide hood towards wall until mounting screws are engaged
in narrow end of (4)
Keyholes.
Tighten mounting screws
securely.
_DO
NOT PUSH ON FAN BLADE.
the
Pushing
on
blade may cause it to interfere with other hood parts.
DUCT
TAPE
[_
Connect ductwork to hood. Use Duct
to make joints
secure and air tight.
PAR20,
50W MAX.
HALOGEN
BULB (2)
- or-
R16,
40W MAX.
INCANDESCENT
BULB (2)
OPERATION
Fan: The 3-position rocker switch (on the left) controls the fan. The
left position is low speed, center position is off, and right position is
high speed. An indicator light shows that the fan is on.
Light: The 3-position rocker switch (on the right) controls the lights.
The left position is low light intensity, center position is off, and right
position is high light intensity.
CLEANING
_lb
ARNING:
To reduce
the risk
of electric
shock,
disconnect
from
power
supply
before
cleaning.
Aluminum
mesh filters:
Clean frequently using hot water and a
mild detergent. Filters are dishwasher safe.
Charcoal filters:
Clean filter surfaces frequently with a damp cloth
and a mild detergent.
DO NOT immerse filters in water or put in
dishwasher. The special "Clean Sense" feature indicates when the
filter is to be replaced. The blue and yellow strips will blend to green
when it is time to change the filter. The "Clean Sense" feature works
best when facing toward the cooking surface.
To clean hood: Remove filters. Use a damp cloth and a mild deter-
gent to wipe all grease-laden surfaces. Use care when cleaning fan
blade - it must not become bent or misaligned.
DO NOT ALLOW
WATER TO ENTER MOTOR. Make sure all surfaces are completely
dry before re-installing filters and restoring power.
Motor is permanently
lubricated. Do not oil or disassemble motor.
Install (2) PAR20, 50 W Maximum Halogen
Bulbs
or (2)
R16, 40 W Maximum Incandescent
Bulbs. Purchase bulbs
separately.
CAUTION:
Bulbs may be hot! Refer to bulb packaging
for further
information.
El
filters and make
fan blade turns
Turn
Replace
sure
freely.
on
power at service panel, and test for proper operation.
Publicidad
