dBTechnologies VIO S118 Manual Del Usuario página 39

English
The assembly of the 2 modules A and B requires a few easy steps:
• On module A remove the pins [C], raise the retractable brackets [A] and [B] and fasten them to the new
position using the pins [C].
• Remove all the pins [D] and [E] from module B, place it on top of module A, inserting the brackets as shown.
Then fasten the front and rear sides of the two modules using the pins [D] and [E] of module B.
The assembly system is symmetrical: the same procedure applies to cardioid vertical configuration.
VIO-S118 Cod. 420120259 REV. 1.0
39