i
I (
19, detail 1-2-3-4) Clean the lower part of the glass panel,
cut the seal to size; remove the protective strip from the seal as
shown and fix it to the glass panel on the inside.
i
I (
19, detail 5) From the outside, apply a silicone bead along
the entire glass panel, so as to close the gap between the tub rim
and the lower side of the glass panel itself.
(part 6-7) Then apply the other half of the seal.
Accessory assembly
i
I
(
20, detail 1) Where required, fix the suction nozzle cover
with o-ring using the specific screw.
i
I
(
20, detail 2) Where required, install Twist Jets or Hydro
Jets as shown:
(Twist Jet): insert the nozzle in the nozzle body then fit the cover
so that the pin is inserted in the central hole of the nozzle.
(Hydro Jet): insert the plastic spring in the nozzle body, then rest
the nozzle on top and fit the cover.
Make sure that the grooves under the cover and inserted in the
corresponding notches in the nozzle body.
i
I
(
20, detail 3) In models provided with air blower, snap the
covers onto the small nozzles on the bottom of the tub.
I Check perfect operation of the device and check for
leakages, specifically from the plumbing and the drain.
Panel assembly
i
I (
21) Fix the metallic elastic supports (L), by means of the two
self-tapping screws to the screw anchors (N) under the tub rim.
i
I (
22) Insert the springs (P) on the pins in the corners of the
tub and make them slide upwards, until they abut and are arranged
inside the rim. Insert the ring (R) in the specific groove of the pin.
i
I (
23) Adjust the brackets (Z) as shown; make sure that the
brackets are as parallel to the tub rim as possible (dashed line in the
figure).
Then adjust the height by means of the ring nut (Y) and adjust the
distance with respect to the projection of the tub rim.
Then tighten the nut (W).
i
I (
24) If you need to install the side panel, insert it between the
springs (P) and the tub rim, lifting it until the holes coincide with the
slots in the brackets (Z); then fix with the self-tapping screws
included and corresponding plastic washers.
i
I (
24) Then approach the front panel to the tub and insert it
between the central springs (L), the side springs (P) and the tub rim.
Incorporate the side panel, for rectangular models.
I Apply the white caps included on the screws (U).
Complements
i
I (
25, detail 1) Apply a silicone bead between the tub rim and
the wall.
i
I (
25, detail 2) Position the headrest on the backrest side.
CAUTIONS
JACUZZI EUROPE S.p.A. will not be liable if:
the installation is performed by unqualified personnel and/or
personnel not enabled to perform the installation itself;
the rules, regulations and laws in the matter of electric systems in
buildings in force in the country where the device is installed are
disrespected;
the installation and maintenance instructions illustrated in this
manual are not respected; unsuitable and/or non-certified
materials are used for installation;
incorrect operations are performed which reduce the degree of
protection of jets and which modify the electrocution protection
direct or indirect contact or create isolation, current dispersion or
anomalous overheating;
changes are made to components of parts of the device
with respect to supplied conditions, which will devoid the
manufacturer's liability;
the device is repaired by unauthorised personnel or using non-
genuine spare parts made by Jacuzzi Europe S.p.A.
11