Störungen - Oase Solarsafe 17 Instrucciones De Uso

D
Störungen
Störung
LED blinkt nicht mehr
Akku ist nicht lange nutzbar
LED zeigt bei Sonneneinstrah-
lung keine grün blinkende LED
Beleuchtungsausgang wird
nicht aktiviert
GB
Information about this operating manual
Please read the operating instructions and familiarise yourself with the unit prior to using it for the first time. Adhere to
the safety information for the correct and safe use of the unit.
Intended use
The Solarsafe 17/41 series, in the following text termed unit, is exclusively intended for the power supply to Oase Solar
sets and must only be charged in conjunction with Oase Solar modules.
Use other than that intended
Danger to persons can emanate from this unit if it is not used in accordance with the intended use and in the case of
misuse. If used for purposes other than that intended, our warranty and operating permit will become null and void
CE Manufacturer's Declaration
We declare conformity in the sense of the EC directive, EMC directive (89/336/EEC) as well as the low voltage directive
(73/23/EEC). The following harmonised standards apply: EN 60335-1, EN 55014.
Safety information
OASE has manufactured this unit according to the highest quality standards and the valid safety regulations. Despite the
above, hazards for persons and assets can emanate from this unit if it is used in an improper manner or not in accordance
with its intended use, or if the safety instructions are ignored.
For safety reasons, children and young persons under 16 years of age as well as persons, who cannot recognise
possible danger or who are not familiar with these operating instructions, are not permitted to use the unit!
Please keep these operating instructions in a safe place! Also hand over the operating instructions when passing the unit
on to a new owner. Ensure that all work with this unit is only carried out in accordance with these instructions.
The combination of water and electricity can lead to danger for life and limb, if the unit is incorrectly connected and
misused.
Never operate the unit when submersed or standing in water; only charge it using the Solar module. Never open the unit
housing or its attendant components, unless this is explicitly mentioned in the operating instructions. Compare the
electrical values of the power supply with those on the type plate on the packing or on the unit itself. For your own safety,
consult a qualified electrician when you have questions or encounter problems! Protect the connection cable when
burying to avoid damage.
Installation
The unit is operated in horizontal position!
Start-up
Connect the battery prior to starting. For this purpose, remove the hood and join the connection plugs. When delivered,
the battery is fully charged and operational. Prior to this observe the following operating steps: Prior to switching on,
connect the OASE Solar module to the unit (A/B). The status indicator (2) at the front shows the operating condition,
flashing green = the accumulator is being charged and operational, flashing yellow = the accumulator is not being charged
but operational, flashing red = the accumulator is discharged and needs recharging.
The unit has 2 inputs and 3 outputs which are different connections to avoid confusion. One OASE Solar module each
can be connected to the input connections (A/B). Connection (C) directly supplies energy via the Solar modules, whilst
the excess energy is used at the same time to charge the battery. Connection (D) is used for direct consumption from the
battery and ensures an absolutely consistent performance of the electrical consumer. Connection (E) operates with an
automatic twilight system for those electrical consumers which are to switch on during the evening hours. Switching off
after 6 hours is also automatic. The outputs D and E are switched off when the lamp is red and protected from deep
discharge.
Important! Do not short-circuit the accumulator!
6
Ursache
Akku vollkommen entladen
Akku ist defekt
Akku wird nicht voll
Akku ist defekt
Elektronik defekt
Solarmodule werden künstlich beleuchtet
Abhilfe
Solarpanel oder Ladegerät anschließen
Akku austauschen
längere Zeit bei ausreichend Sonne aufladen
Ladegerät anschließen
Akku austauschen
Reparatur
Solarmodule gegen Lichtquelle abschirmen
Signature: