Important; Deploying Steelhead Mobile In Environments With Firewalls; Installing On A Rack; Connecting The Power - Riverbed Steelhead CX Guía Rápida De Instalación

Installing and Deploying Steelhead Mobile
IMPORTANT: The default MSI package that ships with Steelhead Mobile is designed to be suitable for most network
environments. Typically, you can install and deploy Steelhead Mobile without modifying the default policies that ship
with the product. Consider deploying Steelhead Mobile to your Mobile Clients using the default policies provided, and
modifying them only if necessary.
Make sure you have enough memory on your Mobile Clients to run Steelhead Mobile.

Data Store Size (GB)
1
2
5
10
15
20

2. Deploying Steelhead Mobile in Environments with Firewalls

If you need a solution for remote access users only, a location for the Mobile Controller might be in the DMZ
next to a VPN concentrator with firewalls on each side. Users who need access to the Mobile Controller can
connect to it from outside the DMZ zone. This scenario requires that the client-side network firewall have
port 7801 available. The server-side firewall must have ports 22, 80, 443, 7800 and 7870 open.
If you are using application control, you need to allow rbtdebug.exe, rbtmon.exe, rbtsport.exe, and
shmobile.exe.
Figure 2-2. Steelhead Mobile Deployment

3. Installing on a Rack

If your model has a bezel, remove it.

Align the screw holes on the flanges with the screw holes on the rack.

Insert and tighten the screws on each side of the appliance.


4. Connecting the Power

If your model has a master power switch, make sure it is in the off position (on the rear panel).

Getting Started Guide
Memory Usage (MB)
81
100
112
161
171
228
Installing and Deploying Steelhead Mobile
55