Working With The Tool - Honsel Rivdom ZERO 12 V Instrucciones Originales De Uso

OPERATION AND HANDLING OF
THE BATTERY
Charge the batteries (F) only in chargers
recommended by the manufacturer.
There is a risk of fire if a charger
designed for a given type of battery is
used with other batteries.
Use only the specified batteries in the setting tools.
The use of other batteries can lead to injuries and
the risk of fire.
Keep the batteries not in use (F) away from paper
clips, coins, keys, nails, screws or other small metal
objects that could cause bridging of the contacts.
A short circuit between the battery contacts can
cause burns or a fire.
If improperly used or damaged, liquid can escape
from the battery (F).
Avoid contact with this liquid. In the event of acci-
dental contact, wash off with water. If the liquid gets
into the eyes, obtain additional medical assistance.
Escaping battery liquid can cause skin irritation or
burns.
SERVICE
Have your setting tool repaired only by
qualified specialist personnel and only
with original spare parts. This will ensure
that the safety of the setting tool is
maintained.
COMMISSIONING
CHARGING THE BATTERY
Note: The battery (F) is partially charged on
delivery. In order to ensure the full performance of
the battery (F), charge the battery (F) completely in
the charger before the first use. Observe the notes
on the state of charge on the charger. The Li ion
battery (F) can be recharged at any time without
shortening its service life. Interruption of the charg-
ing cycle does not damage the battery (F). The
charger is equipped with a temperature monitoring
device that permits charging only in the tempera-
ture range between 0°C and 40°C.
16 | English
PREPARING THE SETTING TOOL
Fit the collecting bin (E) by turning to the right.
Push the battery (F) into the foot of the setting tool
from the front and ensure that the battery (F) is
properly engaged.
RIVDOM ONE
Press the trigger (I) and hold it depressed. Fit the
appropriate nosepiece (A) for the fastener you wish
to set using the open-jaw wrench supplied. After
changing the nosepiece, release the trigger.
RIVDOM ZERO / RIVDOM TWO / SF / 2.8 20 V
Press the trigger (I) and hold it pressed for 5 sec-
onds (see section Extended trigger functions). Fit
the appropriate nosepiece (A) for the fastener you
wish to set. After changing the nosepiece, press
the trigger again.
The setting tool has further functions that are con-
trolled with the trigger.

WORKING WITH THE TOOL

SETTINGS FASTENERS
Insert the mandrel of the fastener into the nose-
piece (A). Now insert the fastener into the parts to
be riveted. For a good setting result, ensure that
the parts and the head of the fastener are resting
on one another without a gap. Press the trigger
until the fastener mandrel is sheared off. Hold
the setting tool so that the collecting bin is facing
downwards to ensure that the sheared fastener
mandrel drops into the collecting bin.
When working with cover cap, hold the setting
tool with the nosepiece (A) facing downwards
after each set fastener to ensure that the sheared
fastener mandrel drops out of the tool to the front.
Do not use fixed or retainer nosepieces together
with the cover cap. This would result in damage to
the tool!
EXTENDED TRIGGER FUNCTIONS ALL
RIVDOMS (NOT RIVDOM ONE)
The setting tool has two further functions that are
controlled with the trigger.
1. Service position: Press the trigger (I) for
5 seconds (until the white LED (H) on the tool
starts to flash 1/sec) and release again. The
setting tool remains in the rearmost position.
The nosepiece (A) can now be easily changed