Special Safety Precautions - Max 49001 Manual De Instrucciones

Special safety precautions

If using as a screwdriver, never use on impact
drill setting.
Do not use damaged or worn drill bits and
always use the correct type of bit for the job.
Secure small items in a vice or similar. Never
hold the item in your hand!
Check for concealed power cables, pipes etc
in the items or surface you are going to drill.
Place a piece of scrap wood under the item
if possible. Avoid the drill damaging objects
under or behind the item, e.g. when drilling
in walls.
Always maintain a � rm grip on both handles
when using the machine.
Avoid blocking the ventilation slots with your
hands.
The drill must not be in contact with
anything when starting it.
Always use ear protectors when using the
hammer drill function.
Drilling certain substances can cause harmful
dust. Always wear a mask.
The drill must be totally stopped before
switching between drilling and hammer
drilling, changing direction or drill speed.
Never put the drill down if the chuck is
still rotating (e.g. if the lock button is still
depressed). Wait until the chuck has stopped
completely before putting the drill down,
and pull the plug out of the socket if it is not
to be used further.
Avoid touching the drill bit after use. It may
be very hot.
Always secure the chuck key in its holder
when not in use
Preparation and adjustment
Turning the support handle
The support handle (7) can be rotated
around the drill chuck to a position to suit
- e.g. vertically under the machine, horizontal
out to either side.
Changing bits
Insert the chuck key in one of the three holes
on the side of the chuck (8), turn to open.
Insert the desired bit in the chuck and turn
the chuck key the opposite way until the
chuck has a � rm grip on the bit.
Check that the bit is in the centre of the
chuck and is secure.
GB
25