Noise Risk - IMER M400 SMART Manual De Uso & Mantenimiento

NOISE RISK

Please be reminded that checking the use of IPDs is delegated to the
employer.
IMER INTERNATIONAL S.p.A.
M400 SMART
Trouble
The motor does not
start when the start
switch is pressed
Cooling water fails
to reach the blade
The blade does
not cut
* Operation to be carried out by an electrician
The machine must be disposed of according to the current
regulations.
The barred bin symbol indicates that at the end of its service life
the product must be scrapped separately from other materials.
The manufacturer is responsible for separate scrapping of the
equipment at the end of its service life. The user must therefore
contact the manufacturer and follow the instructions given by
the latter for separate scrapping of the equipment at the end of
its service life.
Separate scrapping for subsequent recycling, treatment and
eco-compatible disposal contributes to avoiding negative effects
for the environment and for the health of persons, and promotes
the reuse/recycling of the materials of which the equipment is
fabricated.
Incorrect/illegal scrapping is punishable by law.
13
Causes Remedies
Current does not reach Check the line *
the supply line
The socket and plug Restore correct
are not connected connection
properly
The differential switch Turn the differential
is off switch on
The power cable from Change the cable *
the plug to the panel
is cut off
An electric wire inside Restore the connection *
the motor terminal strip
is cut off
An electric wire inside Change the switch *
the panel is cut off
The start switch is Change the switch *
faulty
Low water level in tank Restore the water level
Current fails to reach Check the pump
the pump electrical supply *
Pump failure Change the pump *
Remove the blade
opposite direction to and reposition it in the
that of rotation direction shown on the
blade label
Worn blade Change the blade
GB