Safety Notices For Milling Cutters - Parkside POF 1200 B2 Traducción Del Manual De Instrucciones Original

Keep cutting tools sharp and
•
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
Use the power tool, accessories
•
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation.
• Carefully inspect the area to be cut
and remove all wires or other foreign
bodies.
Service
Have your power tool serviced
•
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Safety notices for milling
cutters
Warning! Milling can result in
the formation of dusts hazardous to
health (e.g. arising from materials
with paints containing lead, materi-
als containing asbestos or some
wood types), which can pose a risk
to the operator or persons nearby.
Make sure that the workplace is
well ventilated. Always wear safety
goggles, safety gloves and respira-
tory protection. Attach a dust ex-
traction system.
Hold the power tool on the in-
•
sulated handle surfaces, as the
cutter might hit its own power
cable. Contact with a live wire can
also cause a charge in metal parts of
the appliance and result in an electric
shock.
Fasten and secure the work-
•
piece by means of clamps or
with another method on a sta-
ble underground. If you hold the
workpiece only with your hand or
against your own body, it will stay
instable and this can lead to a loss of
control.
The permissible rotation speed
•
of the attachment tools must be
at least as high as the highest
rotation speed indicated on the
power tool. Accessories that run
faster than the permissible speed can
be destroyed.
Cutters and other accessories
•
must be exactly matching the
tool holder (collet chuck) of your
power tool. Attachment tools that
are not exactly matching the tool hold-
er of the power tool rotate unevenly, vi-
brate very strongly and can ultimately
lead to a loss of control.
Ensure that the cutter is assem-
•
bled correctly. A cutter that is not
assembled correctly can break during
the milling or be ejected and present a
risk of injury.
Move the power tool against
•
the workpiece only when it is
turned on. Otherwise, there is a risk
of kickback if the attachment tools jam
in the workpiece.
Do not put your hands in the
•
cutting area and neither on the
cutter. Hold the additional han-
dle or the motor housing with
your other hand. When holding
the milling cutter with both hands, they
cannot be injured by the cutter.
Never mill over metal objects,
•
GB MT
61