Operation; Switching On And Off; Pre-Selecting The Rotation Speed - Parkside POF 1200 B2 Traducción Del Manual De Instrucciones Original

GB MT
5. Slowly press down the machine
until the cutter contacts the work-
piece.
6. Fasten the clamping lever (19) by
pushing it to the left.
Rough adjustment:
7. Slide the depth stop (17) down-
ward until it rests on the step limit
(14).
8. Adjust the depth stop (17) to the
desired cutting depth and tighten
the locking screw (18).
Fine adjustment:
9. For the fine adjustment, turn the
rotary knob (2) to the desired
measure, wherein one complete
rotation equals 1 mm:
counter-clockwise rotation: great-
er cutting depth
clockwise rotation: lesser cutting
depth
10. After the fine adjustment, you can
set the scale below the rotary
knob (2) to the "0" position. For
this purpose, press the ring (2a)
below the rotary knob downward
and turn it into the desired posi-
tion.
We recommend testing the cutting
depth adjustment by means of a test
cut on a reject piece.
Gradual milling
To mill in multiple steps with greater cutting
depth, the cutting depth can be adjusted
with the step limit (
1. Turn the step limit (
engages in the highest step below the
depth stop (
64
14).
14) so that it
17).
2. Set the further cutting depth with the
lower steps of the step limit (

Operation

Wear breathing protection
(fine dust mask of protection class
PPP2).

Switching on and off

1. Connect the machine to the pow-
er supply.
Make sure that the net voltage
matches the voltage rating indi-
cated on the device's type plate.
2. Switching on: Keep the safety
lock (5) pressed and press the
on/off switch (6). Then release
the safety lock.
3. Switching off: Release the on/off
switch (6).
Pre-selecting the rotation
speed
You can pre-select the maximum rotation
speed on the handwheel for the rotation
speed pre-selection (
switch ( 6) can only be pressed up to
the specified speed.
• Adjust the desired rotation speed on
the handwheel for the rotation speed
preselection (
1-2 = low rotation speed
3-4 = medium rotation speed
5-7 = high rotation speed
The suitable rotation speed is pre-selected
depending on the work material, the cutter
type and the work conditions. With large
cutter diameters and hard workpieces,
choose lower rotation speeds and with
14).
3). The on/off
3).