Residual Risks; Initial Operation; Inserting/Changing Cutters - Parkside POF 1200 B2 Traducción Del Manual De Instrucciones Original

GB MT
nails or screws. The milling cutter
can be damaged and lead to in-
creased vibrations.
Use suitable detectors in order
•
to find hidden supply lines or
ask the local utility company.
Contact with electrical cables can lead
to electric shock and fire, contact with
a gas pipe can result in an explosion.
Damage to a water pipe can lead to
property damaged and electric shock.
Do not use any blunt or dam-
•
aged tools. Blunt or damaged tools
can cause uncontrollable situations.
Hold the power tool tightly with
•
both hands while working and
ensure a secure footing. The
power tool is guided more securely
with both hands.
Wait until the power tool has
•
stopped before placing it down.
The attachment tools can jam and lead
to a loss of control over the power tool.
Avoid contact with the tool or
•
the workpiece immediately af-
ter processing. The parts may be
hot and cause burn injuries.

Residual risks

Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Injuries caused by moving parts;
b) Ear damage if working without ear
protection;
c) Lung damage, if suitable respiratory
protection is not worn;
d) Eye injuries if no suitable eye protec-
tion is worn.
62
e) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the func-
tionality of active or passive medical
implants. To reduce the risk of seri-
ous or lethal injuries, we recommend
that persons with medical implants
consult their doctor and the manu-
facturer of their medical implant
before operating the machine.

Initial operation

Pull out the power plug before car-
rying out any work on the equip-
ment. There is a risk of electrocution
or of injury from moving parts.
Before you turn on the machine, you must
- insert the desired cutter,
- connect the dust suction,
- adjust the cutting depth,
- mount the parallel stop if necessary,
- clamp in the workpiece.

Inserting/changing cutters

To insert and replace cutters, wear
protective gloves to prevent cuts
and burns.
1. Press the spindle locking button
(16) on the front side of the ma-
chine and keep it pressed down.
2. Use the combination wrench (27)
to loosen the cap nut (8) as much