Kobalt KRH 124B-03 Manual De Usuario página 13

OPERATING INSTRUCTIONS
9. Changing Accessory
WARNING
• ALWAYS place the direction-of-rotation selector
(D) in the center-WARNING: ALWAYS place the
direction-of-rotation selector (D) in the center-
lock position when not using the tool, cleaning,
or making adjustments. Failure to do so could
result in accidental starting which can cause
serious personal injury.
Accessory selection
For drilling in wood, metal, and plastic and for
screwdriving, use the corresponding SDS-plus
adapter (not included) to use the normal bit which
is not SDS-plus type.
For hammer drilling/chiseling, use SDS-plus bits.
To Install the Accessory
The dust-protection cap prevents the entry of most
drilling dust into the tool holder during operation.
When installing the bit/adapter, take care that the
dust-protection cap is not damaged. Replace it
immediately if damaged. We recommend having
this carried out by an after-sales service provider.
a. Clean and lightly grease the shank end of the
SDS-plus accessory.
b. Insert the accessory into the chuck with a
turning motion until it engages. The accessory
locks in position automatically.
c. Pull accessory to check that it is locked correctly.
To Remove the Accessory
a. Pull back the locking sleeve (B).
b. Hold the locking sleeve and remove the accessory.
The SDS plus accessory is designed freedom of movement which causes eccentricity when
tool is off-loaded; however, the accessory automatically centers itself during operation without
affecting drilling precision.
NOTE: Do not use bits/chisels with damaged shanks.
9a
9b
13
A
B
B