Operating Instructions - Kobalt KRH 124B-03 Manual De Usuario

OPERATING INSTRUCTIONS

1. To Attach Battery Pack
a. Place the direction-of-rotation selector (D) in
the center-lock position.
b. Align the raised portion on the battery pack
with the grooves on the bottom of the tool,
then slide the battery pack onto the tool, as
shown.
c. Make sure that the battery-release buttons
on the battery pack snap into place and the
battery pack is secured to the tool before
beginning operation.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack
aligns with the groove on the tool and the latches snap into place properly. Improper assembly
of the battery pack can cause damage to internal components.
To Detach Battery Pack
a. Place the direction-of-rotation selector (D) in the center-lock position.
b. Press the battery-release buttons to release the battery pack.
c. Pull forward on the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, the direction-of-rotation selector
(C) should always be in the center-lock position when the tool is not in use or when carrying
the rotary hammer at your side.
2. Direction-of-Rotation Selector
The direction of bit rotation is reversible and is
controlled by a selector (D) located above the
switch. With the rotary hammer held in the normal
operating position:
a. Press the direction-of-rotation selector (D) to
the left for forward rotation.
b. Press the direction-of-rotation selector to the
right for reverse rotation.
c. Setting the selector in the center (lock) position
helps reduce the possibility of accidental
starting when not in use.
The rotation-direction setting is not available for
chiseling mode.
NOTICE: To prevent gear damage, always allow the rotary hammer to come to a complete
stop before changing the direction of rotation.
NOTICE: The rotary hammer will not run unless the direction-of-rotation selector is fully
engaged to the left or right.
1
Battery-release
button
2
9
D