Maintenance; Troubleshooting - Black and Decker NST1118 Manual De Instrucciones

maintenance

WarninG:
To avoid serious injury, remove the battery from
the tool before performing any maintenance.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top
condition, store spare pre-wound spools or bulk line in a plastic,
sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is
recommended you periodically touch-up the sharpness of the
blade with a file.
imPortant: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by
authorized service centers or other qualified service organizations,
always using identical replacement parts.
Battery recycling and the rBrc™ Seal
The RBRC™ (Rechargeable Battery Recycling
Corporation) Seal on the nickel-cadmium battery (or
battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have
already been paid by Black & Decker. In some areas, it is illegal to
place spent nickel-cadmium batteries in the trash or municipal solid
waste stream and the RBRC program provides an environmentally
conscious alternative.
RBRC in cooperation with Black & Decker and other battery
users, has established programs in the United States and Canada
to facilitate the collection of spent nickel-cadmium batteries.
Help protect our environment and conserve natural resources
by returning the spent nickel-cadmium battery to an authorized
Black & Decker service center or to your local retailer for recycling.
You may also contact your local recycling center for information on
where to drop off the spent battery, or call 1-800-8-BatterY.

trouBleShootinG

tool runS SloWlY
• Check that the spool housing can rotate freely. Carefully clean it if
necessary.
• Check that the cutting line does not protrude more than
approximately 5-3/8 inches (136mm) from the spool. If it does, cut
it off so that it just reaches the line trimming blade.
automatic line feeD DoeS not WorK
• Keep the tabs depressed and remove the spool from the spool
housing in the trimmer head.
• Pull the cutting line until it protrudes approximately 5-3/8 inches
(136mm) from the spool. If insufficient cutting line is left on the
spool, install a new spool of cutting line.
• Ensure that the line is not crisscrossed on the spool as detailed
in figure 19. If it is, unwind the cutting line, then wind it back on
the spool neatly so that the lines do not cross.
• Ensure the beginning of the cutting line is pulled tight against the
spool as shown in figure 18.
• Align the tabs on the spool cap with the cut outs in the housing.
• Push the spool onto the housing until it snaps securely into place.
• If the cutting line protrudes beyond the trimming blade, cut it
off so that it just reaches the blade. If the automatic line feed
still does not work or the spool is jammed, try the following
suggestions:
• Carefully clean the spool and housing.
• Remove the spool and check if the lever in the spool housing
can move freely.
• Remove the spool and unwind the cutting line, then wind it on
neatly again. Replace the spool into the housing.
11