FT ICEHOME Ficha Técnica Libro De Servicio página 19

8. Position clamp assembly so the washer is centered directly
over hole. Tighten bolts evenly.
9. Place compression nut and sleeve on tubing, use brass insert
to reinforce polyethylene tubing.
10. Insert tubing all the way into valve and tighten compression
nut with wrench. Do not over tighten.
11. Slowly turn handle clockwise as far as it will go, carefully in-
serting piercing tip trough washer into supply line. Make sure it
pierces the line or cleanly enters the hole drilled into iron pipe.
If it doesn't, check alignment, tighten clamp assembly and re-
peat.
12. To let water flow, turn handle counterclockwise as far as it
will go. Turn on water supply and check for leaks.
19