Sears Kenmore 796.8138 Manual De Uso Y Cuidado página 33

BEFORE CALLING FOR SERVICE (continued)
Display shows error Temperature sensor failure. Turn off the dryer and call for service.
code: tEl or tE2
Lint on clothes Lint filter not cleaned properly.
Laundry not sorted properly.
Excess static in clothes.
Dryer is overloaded.
Tissue, paper, etc., left in pockets.
Remove the lint from the filter before every load.
With the lint removed, hold the filter up to a light
to see if it is dirty or clogged. If it looks dirty,
follow the cleaning instructions in the Care and
Cleaning Section. With some loads that produce
high amounts of lint, it may be necessary to clean
the filter during the cycle.
Some fabrics are lint producers (i.e., a fuzzy white
cotton towel) and should be dried separately from
clothes that are lint trappers (i.e., a pair of black
linen pants).
Use a fabric softener to reduce static electricity.
Be sure to follow the manufacturer's instructions.
Overdrying a load of laundry can cause a buildup
of static electricity. Adjust settings and use a
shorter drying time, or use AUTO DRY cycles.
Divide extra large loads into smaller loads for drying.
Check pockets thoroughly before washing and
drying clothes.
Steam is not generated and no error Check for condensation on the inside of the door
code is displayed, during steam portion of the cycle. Steam is not
directly visible. This is normal.
Check steam feeder drawer:
(1) Make sure steam feeder is filled with water to
the MAX line.
(2) Make sure steam feeder is seated properly
and drawer is fully closed.
(3) Turn the dryer off, then turn back on and
restart the steam cycle.
DO NOT USE DISTILLED WATER - The water level
sensors in the steam generator will not work.
Steam feeder pump not working - call for service.
Garments are still wrinkled at the end Load only one to five garments (or a single bulky
of the STEAM REFRESH cycle, item). Do not mix fabric types.
STEAM REFRESH is most effective on 70/30
cotton/polyblends. Do not use on 100% cotton items.
Water drips clown the door during Steam is invisible. However, under some conditions,
steam cycles, the condensed fog may be seen, or condensation
will form on the inside of the door glass and may
be seen dripping clown the glass.
Drum does not turn during steam cycles. The drum is turned off so that the steam vapor
Cannot see steam vapor at the
beginning of the cycle.
Steam Features Not
Working
Odors are not completely removed at
the end of the STEAM REFRESH cycle.
remains in the drum. The drum will turn for only a few
seconds, once a minute.
Steam is released at different stages of the cycle
for each option. Steam cannot be seen, but
condensation may form on the inside of the door
when steam is being generated.
Some odors are difficult to remove. Fabrics containing
certain difficult odors or very strong odors may not refresh
well and should be washed or dry cleaned instead.
33