Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
KEY DIMENSIONS
AND SPECIFICATIONS
Description
Dryer (Gas and Electric)
Electrical Requirements
Refer to the rating label
Gas Requirements*
NG.
4-10.5
inches WC (Water Column)
Gas Requirements*
LP.
8-13 inches WC
Dimensions
27 in. (W) X 30
1/4
in.
(D) X 38
11/16
in.
(H), 51 3//16 in. (D with door open)
68.6 cm (W) X 76.7 cm (D) X 98.3 cm (H), 130 cm (D with door open)
Net Weight
Electric : 133.6 lb. (60.6 kg) Gas : 137.6 lb. (62.4 kg)
Drying Capacity
IEC 7.4 cu. ft.
*Gas Models Only
LOCATION
REQUIREMENTS
Standard
Installation
- Side View
IMPORTANT:
Read all installation
instructions
completely
before
installing and operating
your dryer.
It is important
that you review this entire manual
before
22 1/2in.
installing and using your dryer. It contains detailed
(57.3cm)
instructions concerning
electrical
connections,
gas
connections
and exhaust requirements.
CHOOSE
THE PROPER LOCATION
• Store and install the dryer where it will not be exposed
to temperatures
below freezing
or exposed to outdoor
weather
conditions.
• Choose a location
with a solid, level floor.
• If the dryer is being installed in a garage,
place the
dryer at least 18 inches (45.7cm)
above the floor.
• Properly ground the dryer to conform
with all
governing
codes and ordinances.
• To reduce the risk of electric
shock, do not install the
dryer in clamp or wet locations.
NOTE: Installing the dryer in a humid space, or installing or
storing the dryer where it will be exposed to the weather or
freezing
temperatures,
may result in rust or other dam-
age that is not covered by the product warranty.
IMPORTANT:
If you are installing
your
dryer
in a
manufactured
or mobile
home,
please
refer
to the
Special
Electrical
Requirements
for Mobile
or
Manufactured
Homes
section.
CLEARANCES
• Most installations
require a minimum 5 inch (12.7 cm)
clearance
behind the dryer for the exhaust ducting.
• Allow minimum
clearances
of at least 1 inch (2.5 cm)
on the sides and back to minimize vibration
and noise.
• Allowing
additional
clearance
for installation
and
servicing
is recommended.
• Be sure to allow for wall, door, or floor moldings that
may increase the required
clearances.
• Allow at least 22 1/2 inches (57.3 cm) in front of the
dryer to open the door.
Standard
Installation
- Front View
00
1in. --,.-I!--
--I_
1in.
(2.5 cm)
27 in.
(2.5 cm)
(68.6 cm)
O
f
3"
(7.6 cm)
_
Vent
48 sq. in. --
(310 sq. cm.)
Vent
24 sq. in.
(155 sq. cm.)
/
3"
I_
(7.6 cm)
i
O
Additional instructions for closet installations:
The closet door must allow for sufflcient airflow. Refer to the
diagram above for minimum vent opening requirements. A
Iouvered door is also acceptable.
Publicidad
Tabla de contenido
