Before Use; Operating The Appliance For The First Time - Hilti VC 60M-X Manual De Instrucciones Original

4.4 Noise and vibration information (measured in accordance with EN 60335-2-69)
The information below applies to the VC 60M-X and VC 60L-X industrial vacuum cleaners.
Sound pressure level L
Uncertainty K
pA
Vibration emission value
Uncertainty (K)
5

Before use

DANGER
Electrical hazards. Fatal or serious injury may result if the vacuum cleaner is not correctly connected to the
electric supply.
▶ Connect the vacuum cleaner only to a properly earthed/grounded power source.
CAUTION
Risk of injury presented by the appliance running away out of control. The vacuum cleaner may run
away out of control if the wheel brakes are not engaged.
▶ Engage the wheel brakes so that the vacuum cleaner stands securely.
5.1

Operating the appliance for the first time

Use a plastic dust bag for picking up harmless or mineral dust and use a non-woven dust bag for
wood chips.
1. Open the two catches.
2. Lift the vacuum cleaner top section away from the waste material container.
3. Remove the accessories and packaging from the waste material container.
4. Fit a suitable dust bag in accordance with the instructions.
5. Fit the vacuum cleaner top section onto the waste material container and close the two catches.
6. Check to ensure that the vacuum cleaner top section is fitted correctly and secured.
7. Connect the suction hose to the appliance.
5.2 Fitting/changing the fabric dust bag
DANGER
Risk of injury. Sharp pointed objects may pierce through the dust bag.
▶ Check that no objects have pierced through the dust bag.
1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the suction head off the waste material container.
4. Close the cap at the mouth of the dust bag.
5. Remove and dispose of the dust bag → page 27.
6. Clean the waste material container with a cloth.
7. Secure the new fabric dust bag in the waste material container.
8. Set the suction head on the waste material container and close the two catches.
5.3 Fitting/changing the plastic dust bag
1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the vacuum cleaner top section away from the waste material container.
4. Use a cable tie to close the plastic dust bag below the punched holes.
5. Remove the plastic dust bag.
6. Clean the waste material container with a cloth.
22 English
pA
2
3
VC 60L-X VC 60M-X
73 dB(A) 73 dB(A)
1 dB(A) 1 dB(A)
< 2.5 m/s² < 2.5 m/s²
0.2 m/s² 0.2 m/s²
2212334
*2212334*