geberit UNIVERSAL Instrucciones De Servicio página 22

Operation
Operation
Clamping the pipes or fittings
Set the pipe support prisms to the required
1
dimension.
Fold up the brackets of the tension devices and insert
2
the parts to be welded.
The pipes or fittings must be inserted in such a way
that the ends to be welded protrude 1 cm from the
tension device.
1 c m
22
1 c m
The pipe supporting prisms must be as far as
possible from the tension devices. Branch fittings and
bends must be placed with the straight section on the
pipe support prisms.
Clamp the pipes or fittings with the adjustable
3
eccentric levers.
If the parts to be welded do not match one another
axially, the right-hand tension device can be moved
to the side by loosening the eccentric lever.
Turn the hand wheel to the right to press together the
4
parts to be welded, and check the fixing of the parts
to be welded.
Tighten with the adjustable eccentric lever if fixing is
5
not adequate.