Indicator Lights - RIDGID B-500 Manual De Instrucciones

Indicator Lights

In some cases, chips will build up between the work
piece and the guide rollers. In most cases, the guide
rollers will ride over the chips with no issue other
than a slight increase in cranking force. If the unit
binds or chips need to be removed during bevelling,
turn the tool off and unplug it prior to removing chips
or moving the tool.
Figure 15A – Bevelling Operation
Indicator Lights
Figure 14 – Indicator Lights
Model B-500 Transportable Pipe Beveller
Lights Illuminated
All
Two Yellow
One Yellow/OneGreen
Two Green
One Green/OneRed
Two Red
Figure 15B – Bevelling Operation
Continually monitor the cord position and tracking of
the beveller. Make sure the cord stays clear of the cut-
ter head. As the bevel is formed, make sure that the
wear plates stay flush to the end of pipe or plate
edge. Stop rotating the hand crank and press the
OFF (O) button. If:
• The wear plates move away from the work piece.
• The cutters do not engage the work piece.
• The process needs to be stopped for any reason.
This will help prevent the beveller from tracking off the
work piece. Repeat procedure starting at step one to
continue bevel.
Do not drive the beveller with a drill, impact tool or
other powered methods – this could damage the
beveller and increase the risk of the beveller coming
off the work piece.
Condition
Plugged in, switch OFF
Crank speed too slow.
Optimum crank speed.
Crank speed too fast.
11