Safety Instructions Relating Specifically To The Equipment - MeisterCraft MES 220 E Traducción De Las Instrucciones De Servicio Originales

MC-5460210-Bediene-1111_MC-5460210-Bediene-1109.qxd 24.11.11 13:50 Seite 58
Any power tool that cannot be
controlled with the switch is
dangerous and must be repaired.
c Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of
starting the power tool accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained
users.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This
58
will ensure that the safety of the
power tool is maintained.
b To avoid hazards, damaged power leads
must be replaced by the manufacturer
or his customer service representative.
6 – Safety instructions
relating specifically to
the equipment
• Use the machine for its intended
purposes only.
• When the machine is in operation,
grasp it with both hands and take a
firm stance.
• Power sockets for use out of doors
must be fitted with residual-current
circuit breaker.
• Never remove chippings or debris
when the machine is running.
• Be sure to remove the power plug
before starting to work on the machine,
during any work breaks or when the
machine is not in use.
• Always keep the power cable well
away from the drilling zone.
• Make sure the machine is turned OFF
before plugging it into the power supply.
• Do not use the appliance in the rain
or wet.
Wear safety glasses! Risk of
injury from split off or flying
material parts.
Wear suitable ear protectors.