Additional Safety Instructions; Noise And Vibration - Flex PE 8-4 80 Manual De Instrucciones

Keep your hands away from the rotating

insertion tool. The insertion tool may
kickback over your hand.
Keep your body out of the area into which

the electric power tool moves when
a recoil occurs. Kickback propels the
electric power tool in the direction
opposite to the movement of the polisher
at the point of pinching.
Work especially carefully near corners,

sharp edges, etc. Prevent the insertion
tool from recoiling off the workpiece and
jamming. The rotating insertion tool has
a tendency to snag on corners, sharp
edges or if it bounces. This causes a loss
of control or kickback.
Do not use a chain or toothed saw blade.

Such insertion tools frequently cause
a kickback or the loss of control of the
electric power tool.

Additional safety instructions

The mains voltage and the voltage

specifications on the rating plate must
correspond.
Do not press the spindle lock until the tool

stops.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power
tool is typically:
– Sound pressure level:
– Sound power level:
– Uncertainty:
Total vibration value (when polishing
painted surfaces):
– Emission value:
– Uncertainty:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
16
80 dB(A);
91 dB(A);
K = 3 dB.
2
a = 2.5 m/s
h
2
K = 1.5 m/s
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 60745 and may be used to compare one
tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ.
This may significantly increase the
exposure level over the total working period.
For a precise estimation of the vibration load
the times should also be considered during
which the power tool is switched off or even
running, but not actually in use.
This may significantly increase the exposure
level over the total working period Identify
additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep
the hands warm, organisation of work
patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
PE 8-4 80