Troubleshooting - Bestway 58482 Manual De Instrucciones

Troubleshooting

Problem
Robot does not capture debris.
Robot stopped moving in the middle of
pool(swivel head still turning).
Robot does not cover the entire pool /
move along the pool wall.
Robot trapped in the narrow place of the
in-ground pool.
Robot moves slowly.
Swivel head does not turn or turns
noticeably slowly.
Debris escapes from the robot.
Debris goes outside the filter cover.
Float sinks.
Robot cannot be charged / recharged.
303021219122_58482_21x28.5cm_ 欧规池底清洁机器人说明书 _ 英
Possible Cause
Battery is low.
Impeller is jammed.
Impeller is broken.
Debris compartment is full.
Robot stopped by obstacle.
Robot is stopped by suction force
from main pool floor drain.
Debris compartment is full.
Operation time is shorter than
expected.
Moving direction is interrupted by
water circulation generated
by filtration system.
Wheel is jammed.
Locking pin position is not correct /
bumper is required.
Robot moves along the pool wall of
round pool.
Not enough space for robot to change
directions.
Debris compartment is full.
Swivel head bottom is jammed.
Side flap is jammed.
Swivel smoothing- ring is broken.
Suction mouth's flap (on cleaner
bottom) is broken.
Draining filter plate is broken or not in
place.
Filter cover net is damaged.
Float is broken and water goes in.
Battery is damaged.
Charging cable is not completely
connected with external adaptor and
robot.
External adaptor is out of order.
7
Solution
Charge the robot again.
Power off the robot and visually check the hole under the debris.
If necessary, contact your dealer for further instructions.
WARNING!
Make sure the robot is powered off before
servicing the device.
Contact your dealer for replacement.
Clean the debris compartment and filter cover.
Check to see that if there is object obstructing the cleaner.
Remove the obstacle.
Turn off the filtration system(See instructions in manual).
Clean the debris compartment
Clean the filter compartment and recharge the robot again for
4.5- 5 hrs
Turn off the filtration system(See instructions in manual).
Check and clean out debris from the wheel.
Follow manual instructions to set up the locking pin position
properly and apply bumper.
Make sure the bumpers have been installed(See instructions in
manual).
Follow manual instructions to put bumper on both ends of robot.
Clean the debris compartment and filter cover.
Check and remove any debris that may be trapped under the
swivel head.
Check and remove any debris that hinders the movement of the
flap.
Replace with a new swivel smoothing-ring. Contact your dealer
for replacement parts.
Suction mouth's flap works like a door to prevent the debris
from escaping from the debris compartment. Contact dealer for
replacement parts and instruction.
Make sure the draining filter plate is in place and replace a new
one if necessary before next use.
Replace with a new filter cover. Contact your dealer for
replacement parts.
Replace with a new float. Contact your dealer for replacement
parts.
Contact dealer for battery replacement.
WARNING!
DO NOT open the robot and replace the battery by yourself. This
could result in severe or fatal injuries and the warranty will be
voided as a result.
Make sure that the charger cable is connected with external
adaptor and robot properly and completely.
Refer to instruction manual.
Contact dealer for replacement.
WARNING!
Using the wrong external adaptor will result
in damaging the robot / battery and voiding the warranty as a
result.