Install The Finished Wall; Troubleshooting - Kohler K-1913 Guia De Instalacion

Cut template.
Mark bath profile line on drywall.

21. Install the Finished Wall

All Installations
If you have not already done so, carefully remove any protective tape from the bath rim, access
panel and trim caps.
NOTE: Use the provided template (if needed) to cut the bottom of the wall material to match the contour
on the rear of the bath.
Cover the framing with water-resistant wall material. Seal the joints between the bath rim edge and
the water-resistant wall material with silicone sealant.
Tape and mud the water-resistant wall material. Install the finished wall to the water-resistant wall
material so it is 1/16" (2 mm) above the bath surface. Seal the joints between the bath rim and the
finished wall material with silicone sealant.
Install the faucet trim according to the instructions packed with the trim.

Troubleshooting

This section is for general aid only. A Kohler Co. Authorized Service Representative or qualified electrician
should correct any electrical problems. For warranty service, call 1-800-4KOHLER from within the USA and
Canada, or 001-800-456-4537 from within Mexico.
Normal Operation Includes:
While filling the bath with water, some water is routed to the receptor tray and drain
through the accumulator drain hose. It is normal to see or hear a trickle of water either
during or immediately after filling. The accumulator is draining into the receptor tray.
1128532-2-G
Caulk the seam of wall and bath.
38 Kohler Co.