Install The Handles - Kohler K-T16106 Manual De Instrucciones

Valve
Body
Threaded
Sleeve
Escutcheon
Nut
Wall Thickness
5/8" to 1-1/4"
(1.6 cm to 3.2 cm)
Apply plumbers
putty.

2. Install the Handles

Determine the thickness of the finished wall.
If the finished wall is less than 5/8" (1.6 cm) thick, use the
supplied hardware kit numbered 1031071.
If the finished wall is 5/8" (1.6 cm) to 1-1/4" (3.2 cm) thick, use
the supplied hardware kit numbered 1031072.
Slide a spline adapter from kit 1031073 onto the stem extension.
Place a stem extension on the valve stem. Secure with the screw
provided.
Thread a threaded sleeve onto the valve body.
Thread an escutcheon nut onto the threaded sleeve.
Apply plumbers putty or other sealant to the back of the
escutcheon according to the putty manufacturer's instructions.
Thread an escutcheon onto the threaded sleeve. Remove any
excess putty or sealant.
Press a handle over the stem extension and move the handle to
the closed position (Hot = Counterclockwise, Cold = Clockwise).
Lever handles should be horizontal when closed.
If adjustment is needed to achieve the desired handle alignment,
remove the handle, screw and spline adapter. Turn the spline
adapter 1/4 turn. Check the handle position. Repeat the
procedure until the proper handle position is achieved. Secure
with the screw.
1032952-2-A
Wall Thickness
Less than 5/8" (1.6 cm)
Stem
Extension
Spline
Adapter
Screw
Escutcheon
4
Escutcheon
Handle
Kohler Co.