Warranty & Service; General Safety Rules - Craftsman 900.116500 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

587857-00
900.116500 sears
1
Auxiliary Side Handle (5)
Spindle Lock Button (3)
Depressed Center Wheel (4)
FULL ONE YEAR WARRANTY ON CRAFTSMAN ANGLE GRINDER
If this Craftsman angle grinder fails due to a defect in material or workmanship within
one year from the date of purchase, Sears will replace it, free of charge.
If this Craftsman angle grinder is used for commercial or rental purposes, this warranty
applies for only 90 days from the date of purchase.
WARRANTY SERVICE
To obtain replacement under this warranty, return the grinder to your nearest Sears
store in the United States.
This warranty applies only while this angle grinder is used in the United States.
This warranty gives you specific legal rights, and you may also have other rights which
vary from state to state.
SEARS, ROEBUCK AND CO., DEPT. 817 WA, HOFFMAN ESTATES, IL 60179
WARNING! Read and understand all
instructions. Failure to follow all instructions
listed below may result in electric shock,
fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
Work Area
• Keep your work area clean and well lit.
Cluttered benches and dark areas invite
accidents.
• Do not operate power tools in
explosive atmospheres, such as in the
presence of flammable liquids, gases,
or dust. Power tools create sparks which
may ignite the dust or fumes.
• Keep bystanders, children, and visitors
away while operating a power tool.
Distractions can cause you to lose control.
Electrical Safety
• Double insulated tools are equipped
with a polarized plug (one blade is
wider than the other.) This plug will fit
in a polarized outlet only one way. If
3/23/04
7:21 AM
ANGLE GRINDER DIAGRAM
On / Off Switch (1)
SEARS WARRANTY

GENERAL SAFETY RULES

the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
a polarized outlet. Do not change the
plug in any way. Double Insulation
eliminates the need for the three wire
grounded power cord and grounded
power supply system. Applicable only to
Class ll tools.
• Avoid body contact with grounded
surfaces such as pipes, radiators,
ranges and refrigerators. There is an
increased risk of electric shock if your
body is grounded.
• Don't expose power tools to rain or
wet conditions. Water entering a power
tool will increase the risk of electric shock.
• Do not abuse the cord. Never use the
cord to carry the tools or pull the plug
from an outlet. Keep cord away from
heat, oil, sharp edges or moving parts.
Replace damaged cords immediately.
Damaged cords increase the risk of
electric shock.
2
Page 2
Lock-On Button (2)
Wheel Guard (6)

Publicidad

Tabla de contenido
loading

Tabla de contenido