Rowenta FIRST CLASS DA1510 Manual De Instrucciones página 4

IMPORTANT RECOMMANDATIONS
• The voltage of your electrical installation must correspond to that of the
iron (220-240V). Always plug your iron into an earth socket. Connecting
to the wrong voltage may cause irreversible damage to the iron and will
invalidate the guarantee.
• If you are using a mains extension lead, ensure that it is corrected rated
(16A) with an earth, and is fully extended.
• If the electric power cord is damaged, it must be replaced by an Approved
Service Centre in order to prevent any danger.
• Do not unplug your appliance by pulling on the cord.
• Never immerse your steam iron in water or any other liquid. Never hold
it under the water tap.
• Never touch the electric cord with the soleplate of the iron.
• Your appliance gives off steam, which may cause burns, especially when
you are ironing close to the edge of your ironing board.
• Never direct the steam towards people or animals.
• For your saftey, this appliance conforms to the applicable standards and
regulations (Low Voltage, Electromagnetic Compatibility, Environmental
Directives).
• This product has been designed for domestic use only. Any commercial
use, inappropriate use or failure to comply with the instructions, the
manufacturer accepts no responsibility and the guarantee will not apply.
ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials which can be recovered or
i
recycled.
Leave it at a local civic waste collection point.

Keep these instructions
DESCRIPTION
1.
Voltage selector
(120/240 V)
2.
Temperature control
3.
Steam switch
4.
High precision tip
BEFORE IRONING
Remove the sticker on the soleplate.
Adjust the voltage selector.
• Adjust the iron to correct voltage for
your location, using a sharp object.
If the voltage selected is 120 V, the iron
will operate at 110 - 127 V.
If it is set at 240 V, the iron will operate
at 220 - 240 V.
Note!
If necessary, check that you are using an adapter which meets the safety
requirements of the country you are in.
Put the handle into the ironing position.
• Press the release button on the`
rear side and raise the handle
until it locks into position.
• For storing proceed in the same
way to close the handle.
STEAM IRONING
Filling the water tank.
5.
Microsteam200 soleplate
6.
Handle water tank
7.
Water filling inlet
8.
Burst of steam button
9.
Handle release
3