Publicidad
Idiomas disponibles
Idiomas disponibles
O w n e r's Manual
I M P O RTANT SAFEGUARDS
• Always grab by the plug to remove from outlet. DO NOT pull on cord.
• Never force the plug into an outlet.
• Never use while drowsy.
• Never block the air openings of the appliance or place it on a soft surface,
such as a bed or couch where the air openings may be blocked. Keep the air
openings free of lint, hair, and the like.
• Never drop or insert any objects into any opening or hose.
• Do not use outdoors or operate where aerosol (spray) products are being
used or where oxygen is being administered.
• The appliance should never be left unattended when plugged in. Unplug
from outlet when not in use, and before attaching or removing parts.
• Do not operate under a blanket or pillow. Excessive heating can occur and
cause fire, electric shock, or injury to persons.
• Do not operate near televisions, personal computers, floppy disks, compact
disks, pagers, cellular phones or other sensitive electronic equipment.
• The Magnassager contains a natural permanent magnet which emits a
negative pulsating magnetic field of 1000 gauss. Individuals with
pacemakers or detached defibrillators may be at risk.
• Do not carry this appliance by the supply cord or use the cord as a handle.
• To disconnect, turn all controls to the OFF position, then remove plug
from outlet.
• Never use pins, knives, tacks or any other metallic fasteners or objects near
the Magnassager.
• Keep children away from this appliance. If swallowed, massage balls may
become lodged in the throat.
• Do not drop or slam the Magnassager against any surface. If dropped on
control knob, it may short circuit. If dropped on the massage balls, it may
impact the magnet and break. Return the appliance to the factory or
manufacturer for examination and/or repair.
• Do not use the Magnassager on patients with pacemakers or internal
defibrillators.
SAVE THESE INSTRUCTIONS
( c o n t . )
(4)
O w n e r's Manual
P roduct Feature s
n User Maintenance
The Magnassager comes pre-assembled. To dismantle for
cleaning, make sure the speed control knob is in the OFF
position and disconnect the unit from the power supply.
The stainless steel balls are suspended in place by a magnet.
To remove the balls from the rotator plate, simply pull
them out with your fingers or shake the unit.
After removing the stainless steel balls from the rotator
plate, detach the plate from the mounting shaft by
pulling down on the rotator plate.
Wash the stainless steel balls and rotator plate with an
anti-bacterial soap. Do not use thinner or other solvents.
Dampen a cloth with a mild soap and wipe the inside and
outside of the Magnassager housing. Do not submerge
Magnassager in water. Allow a few minutes for the
Magnassager to dry.
Periodically, clean the air vents with a dry toothbrush to
remove lint deposits.
n Assembly
Position the rotator plate to slip on to the shaft adapter. The rotator
plate should be flush with the housing after installation.
Place the stainless steel balls into the holes. The magnet should pull them
into place.
n Operation
Note: Always check for metallic objects attached to the bottom of device.
The Magnassager's switch should be in the OFF position when you do this.
While holding the Magnassager, plug in wall adapter. Turn the switch clockwise
to the ON position. Turn knob to desired speed. Apply the Magnassager to
massage site.
n P roduct and Cord Storage When Appliance Is Not in Use.
The Magnassager should be unplugged and stored after each use away from heat
and water. Cord should not be allowed to hang over edge of counter or table or
touch hot or wet surfaces. The cord should be coiled after each use and stored.
(5)
Publicidad
