Trouble Shooting; Disposal And Recycling - Dexter power NC750JS Manual De Uso

Suspected malfunctions are often due to causes that the users can fix themselves. Therefore check the product using this section. In most cases
the problem can be solved quickly.
WARNING! Only perform the steps described within these instructions! All
further inspection, maintenance and repair work must be performed by an
authorised service centre or a similarly qualified specialist if you cannot solve the
problem yourself!
Problem
Product does not start
Product does not reach full power
Unsatisfactory result
Electrical products must not be thrown out with domestic waste. Recycle them at the special disposal centers provided for the
purpose. Contact your local authorities or stockiest for advice on recycling.
The potential effects on the environment and human health as a result of the presence of hazardous substances in electrical and
electronic equipment.
For disposal, this tool also can be returned to the hardware store or vendor (or Dexter dealer).

8. TROUBLE SHOOTING

Possible cause
Not connected to power supply
Power cord or plug is defective
Other electrical defect to the product
Extension cord not suitable for operation with
this product
Power source (e.g. generator) has too low voltage
Air vents are blocked
Blade is worn
Blade not suitable for workpiece material

9. DISPOSAL AND RECYCLING

101
Solution
Connect to power supply
Check by a specialist electrician
Check by a specialist electrician
Use a proper extension cord
Connect to another power source
Clean the air vents
Replace with a new one
Use proper blade
EN