Setting Up Your Oven - Taurus MO20IXM Manual Del Usuario

English
Microwave oven
MO20IXM
MO20WHM
Dear customer,
Many thanks for choosing to purchase a Taurus
brand product.
Thanks to its technology, design and operation
and the fact that it exceeds the strictest quality
standards, a fully satisfactory use and long
product life can be assured.
Read these instructions carefully before
switching on the appliance and keep them for
future reference. Failure to follow and observe
these instructions could lead to an accident.

SETTING UP YOUR OVEN

Names of Oven Parts and Accessories
Remove the oven and all materials from the
carton and oven cavity. Your oven comes with
the following accessories:
Glass tray (1)
Turntable ring assembly (1)
Instruction manual (1)
A - Control panel
B - Turntable shaft
C - Turntable ring assembly
D - Glass tray
E - Observation window
F - Door assembly
G - Safety interlock system
Grill rack (can not be used in microwave function
and must be placed on the glass tray).
Turntable Installation
A - Hub (underside)
B - Glass tray
C - Turntable shaft
D - Turntable ring assembly
- Never place the glass tray upside down. The
glass tray should never be restricted.
- Both glass tray and turntable ring assembly
must always be used during cooking.
- All food and containers of food are always
placed on the glass tray for cooking.
- If glass tray or turntable ring assembly cracks
or breaks, contact your nearest authorized
service center.
Installation and connection
- This appliance is only intended for domestic
use.
- This oven is intended for built-in use only. It is
not intended for counter-top use or for use inside
a cupboard.
- Please observe the special installation
instructions.
- The appliance can be installed in a 60cm wide
wall-
mounted cupboard.
- The appliance is fitted with a plug and must
only be connected to a properly installed earthed
socket.
- The mains voltage must correspond to the
voltage specified on the rating plate.
- The socket must be installed and connecting
cable must only be replaced by a qualified
electrician. If the plug is no longer to accessible
following installation, an all-pole disconnecting
device must be present on the installation side
with a contact gap of at least 3mm.
- Adapters, multi-way strips and extension leads
must not be used. Overloading can result in a
risk of fire.