Inserting/Replacing The Battery; Setting Up; Check Base Plate/Blade Guard; Switching On And Off - Parkside PTS 710 A2 Traducción Del Manual De Instrucciones Original

Inserting/replacing the battery

■ Open the battery compartment cover
Phillips screwdriver.
■ If necessary, remove the used battery.
■ Insert a new 3 V button cell (type CR 2032) in
accordance with the polarity shown. Screw the
lid of the battery compartment cover
on.
CAUTION!
► If operating and adjustment equipment is
used or procedures other than those specified
here are carried out, this may result in
hazardous radiation exposure.

Setting up

NOTE
► The appliance is equipped with a Power on/
control lamp . This lights up green as soon
as the appliance is connected to the mains.
This indicates that the appliance is live.

Check base plate/blade guard

WARNING! RISK OF INJURY!
Always remove the plug from the
mains power socket before carrying
out any work on the appliance.
♦ Check the freedom of movement of the base
plate before each use
♦ Activate the safety lock-out
that position. Lower the circular saw. In this way,
you can test the function of the base plate
must move freely. It may not jam.
♦ After letting go, it must be move smoothly back
to its starting position of its own accord.
│ GB │ IE
■ 12
with a
back
.
and keep it in
. It
Switching on and off
Switching on
♦ Activate the safety lock-out
that position.
♦ Press the ON/OFF switch
running, you can release the safety lock-out
Switching off
♦ Release the ON/OFF switch

Selecting the cutting depth

NOTE
► We generally recommend setting the cutting
depth to approx. 2 mm more than the thickness
of the material. This ensures that you achieve
a clean cut.
♦ Let go of the quick-release lever of the cutting
depth preselector
depth on the scale
lever tight again.

Fitting the rip fence

♦ Loosen the screw for the rip fence
base plate . Insert the rip fence
rip fence slot . Retighten the screw for the
rip fence .

Handling the circular saw

1. Place the machine on the material. If necessary,
align the machine with the rip fence
marked line.
2. Activate the safety lock-out
that position. Press the ON/OFF switch
3. Press the appliance forward to lower the circular
saw. You can now release the safety lock-out
4. Saw by applying moderate pressure.
and keep it in
. Once the saw is
.
. Set the desired cutting
. Clamp the quick-release
on the
into the
or on a
and keep it in
.
PTS 710 A2
.
.