CIBIN Alaska Manual página 11

C) LIFT the monobloc with the ropes (with an adequate load bearing capacity) mounting special hooks at both ends in order to
hook them to the two lifting points on the top of the monobloc. Balance the weight with caution! (Fig.1.2.2.d).
D) SLOT the monobloc into the hole previously made in cold room wall (Fig.1.2.2.e).
GB
Fig.1.2.2.e
Fig.1.2.2.d
E) FASTEN the monobloc to the wall with the supplied brackets (Fig.1.2.2.f). The monobloc is to be fastened to the wall with
screws.
F) INSULATE the cuts in the wall with putty or silicone and fasten the internal frame with screws (Fig.1.2.2.g).
G) INSTALL the cold room light in the most comfortable position for use.
WARNING!! This machine has not been designed for installation in environments with a potentially explosive atmosphere.
Fig.1.2.2.f
Fig.1.2.2.g
71