AnMo Electronics Dino-Lite Manual De Usuario página 9

DinoCapture 2.0 User manual
Tool bar
The tool bar is divided into three parts:
Draw tools - The draw tool set allows you to write text and draw
on the images. The bar is located below the preview window
management bar.
Measurement tools – Many different measurement types can be
done with the measurement tools. The double flash icon gives you
access to the grid and ruler settings.
Notice: The measurement and calibration feature is only available
for certain models. For the DinoEye models, it is recommended to
make calibrated measurements only. Please contact a local sales
representative for further information.
Line
Continuous
line
Point to line
8 English
Left click and drag to the desired length, and click
again to finish.
Click and drag to form one section of distance, click
again to start another section. Continue until the
total desired distance is measured. Double click to
finish.
Create a line to represent the base by clicking
once to start, drag, and then click again to set the
endpoint. Branch off from the base line to start
measuring the line that is 90 degrees from the base
line and a final click to finish the measurement.