Boneco U7135 Manual Del Usuario página 18

Operation of the 7135 model
en
F E D C
18
A) On-off switch
Switch the air humidifier on or off by pressing button A.
1 2
B) Hygrostat (setting the humidity level)
Set the desired humidity in % by pressing button B. A rela-
tive humidity of between 40% and 60% is recommended.
The humidity can be set between 40% and 75%. The
measurement accuracy is +/- 5%. As soon as the humidity
exceeds the desired setting, the appliance switches off. The
device does not switch off if the display is set to "Co" (con-
A
B
tinuous operation). The expected value will be indicated
during selection. After a few seconds, the display automat-
ically shows the current value.
C) Setting the timer
With button C you can set the humidifier to operate for
between 1 and 9 hours, or on continuous operation. When
selecting the desired time, "TIME" will be shown on the
display. Once the timer is activated, the display goes out.
D) Mist output (regulating mist output)
The mist output can be regulated by pressing button D sev-
eral times. If the red bars are displayed, you have selected
the highest level of mist output.
E) Operation with water pre-heating
Button E is used to switch the pre-heating function on or
off. Switching the function on pre-heats the water to 80 °C
before it enters the nebuliser space. The mist will now be
emitted at a pleasant 40°C. The advantages of this are that
the room temperature does not fall and water cleanliness
is significantly improved (bacteria are killed).
F) Automatic mode and Sleep mode
The automatic and sleep mode "ZZZ" can be activated by
pressing button F. If the automatic function is activated
("AUTO" appears on the display), the ideal air humidity is
maintained relative to the temperature. This is regulated
using the output quantity and the preset expected value. If
the "ZZZ" function is set, the expected humidity is 60%; the
time setting is automatically set to 8 hours; the heating ele-
ment is switched on. In addition, the output quantity is reg-
ulated, depending on the difference between the expected
and the actual values.
1) Empty indicator
The water level is easy to see, thanks to the transparent
water tank. The appliance also shows on the display (sym-
bol 1) when it needs to be topped up with water. Please read
the chapter "Filling the tank" for more information.
2) Cleaning indicator
If symbol 2 and "CLEAN" appear on the display, the appli-
ance should be cleaned as recommended by the manufac-
turer. This symbol comes on automatically every 2 weeks,
depending on the level of use. The display can be cancelled
by depressing button A for between 10 and 15 seconds.