Ec Declaration Of Conformity - Milwaukee M18 FBPV Manual Original

to plastics and other insulated parts. Never use flammable or
combustible solvents around tools.
Depending on the number of running hours – the dust filter should
be renewed. Keep the machine clean with a dry cloth, and a small
amount of spray polish.
Never spray water on to the upper section of the vacuum cleaner.
Danger for persons, risk or short-circuiting.
For user servicing, the machine must be dismantled, cleaned and
serviced, as far as is reasonably practicable, without causing risk
to the maintenance staff and others. Suitable precautions include
decontamination before dismantling, provision for local filtered
exhaust ventilation where the machine is dismantled, cleaning of
the maintenance area and suitable personal protection.
During maintenance and repair work all contaminated parts that
could not be cleaned satisfactorily must be:
• Packed in well sealed bags
• Disposed of in a manner that complies with valid regulations for
such waste removal.
The appliance should be regularly inspected by a qualified service
technician. For example, check the filters for damage and check the
GB
airtightness of the appliance and the proper functionality of the
control mechanism.
The use of non-genuine spare parts, brushes and accessories
can impair the safety and or function of the appliance. Use
only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described,
please contact one of our Milwaukee service agents (see our list of
guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state
the Article No. as well as the machine type printed on the label
and order the drawing at your local service agents or directly at:
Techtronic Industries GmbH, Max-Eyth-Straße 10, 71364 Winnen-
den, Germany.
STORAGE
The appliance must be stored in a dry place and protected from
frost.
CAUTION: This machine shall be stored indoors only.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that the product described
under "Technical Data" fulfills all the relevant provisions of the
directives
2011/65/EU (RoHS)
2006/42/EC
2014/30/EU
and the following harmonized standards have been used.
EN 60335-1:2012+A11:2014+A13:2017
EN 60335-2-69:2012
EN 62233:2008
EN 55014-1:2017
EN 55014-2:2015
EN 50581:2012
Winnenden, 2018-07-04
English
14
Alexander Krug / Managing Director
Authorized to compile the technical file
Techtronic Industries GmbH
Max-Eyth-Straße 10, 71364 Winnenden, Germany
SYMBOLS
CAUTION! WARNING! DANGER!
Remove the battery pack before starting any work on the
appliance.
Please read the instructions carefully before starting the
machine.
Please read the instructions carefully before starting the
machine.
Accessory - Not included in standard equipment, available
as an accessory.
WARNING: This machine is for dry use only.
Safety class III
V
Volts
Direct Current
Dust Class L (IEC 60335-2-69)
The dusts which belong to this class have OEL
values > 1mg/m³
Do not dispose electric tools, batteries/rechargeable
batteries together with household waste material.
Electric tools and batteries that have reached the end of
their life must be collected separately and returned to an
environmentally compatible recycling facility. Check with
your local authority or retailer for recycling advice and
collection point.
European Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark