Charging Usb Devices; Troubleshooting - Silvercrest SFPW 360 B1 Manual De Instrucciones

Charging USB devices

Use of the USB port
power adapter u is connected .
►
♦ Connect your USB device to the USB port
to charge it .
♦ Disconnect your USB device from the USB port

Troubleshooting

Synchronisation with WWVB signal not
possible
■
Connected USB device is not charging
■
■
■
■ 22
_330014_SFPW360B1_LB9.indb 22
Ensure that the power consumption of the USB
device is not higher than 800 mA . For more
information, refer to the instruction manual of
your USB device .
w once it has completely charged .
Disruptive obstacles or other interference sources
such as concrete walls or other radio transmission
devices are interfering with WWVB signal reception .
Change the installation location (e .g . near a
window) and try again .
The projection alarm clock is not connected to the
power .
Connect the power adapter u to the projec-
tion alarm clock .
No plug connection to USB device .
Check the plug connection .
The charging current of the connected USB device
is too high (> 800 mA) .
The USB device cannot be charged by the
projection alarm clock .
│
US - EN
w is only possible during
SFPW 360 B1
w
03.09.19 12:2