Publicidad
Step 16
NOTE: You will need a Tape Measure in this step. Each BACK will use eight NAILS in this step.
å
Carefully lay your unit onto its front edges. We have provided a Nail Holder tool to use in this step for proper placement of the
å
NAILS. We will refer to parts of this tool as the bead, off set edge, and nail slot which is important to follow for proper assembly.
Diagram 1. Place a BACK (Q) into the lower edge of the LEFT END (B) with the top edge of the BACK (Q) against the
å
bottom surface of the TOP (T).
Diagram 2. Place the bead of the Nail Holder down between the BACK (Q) and LEFT END (B) 1-1/2" from the corner.
å
Place a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL through the BACK and into lower edge of the LEFT
END. Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer. Finish fastening the BACK
to the LEFT END with the hammer and Nail Holder placing NAILS approximately 5-1/2" apart.
Diagram 3 and 4. To fasten the remaining two edges of the BACK (Q) place the off set edge of the Nail Holder down.
å
Place a NAIL into the nail slot of the Nail Holder. Tap the NAIL through the BACK and into edge of LEFT UPRIGHT (E) and
SHELF (H). Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer. Finish fastening the
BACK to the LEFT END with the hammer and Nail Holder placing NAILS approximately 5-1/2" apart.
Repeat this step for the remaining BACK (Q) fastening it to the RIGHT END (A), RIGHT UPRIGHT (D) and SHELF (H).
å
Nail
Holder
Place packing material
under the BRACE (F)
for suppport.
A
F
Off set edge
Page 20
Off set edge
Nail slot
Bead
Q
D
4.
Lower edge
1.
1-1/2"
Off set edge
T
H
E
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
419958
3.
(16 used in this step)
1-1/2"
Bead
Q
B
Caution
www.sauder.com/services
1N
NAIL
2.
Publicidad
