Publicidad
Step 17
NOTE: You will need a Tape Measure in this step. Each back will use six NAILS in this step.
å
Unfold the BACKS (P) and lay them into the lower edges of the ENDS (A and B) as shown in diagrams #1 and #2.
å
Fasten the BACKS (P) to the BRACE (F) and VERTICAL BRACE (N). Use eight CLIPS (67G) and eight BLACK 9/16" LARGE
å
HEAD SCREWS (1S).
NOTE: The CLIPS should wrap around the edges of the BACKS and the teeth of the CLIPS should bite into the BRACES as
å
you tighten the screws. Follow diagrams #3 and #4
Fasten the remaining edges of the BACKS to the ENDS (A and B) and BOTTOM (C) using the Nail Holder and NAILS (1N).
å
The NAILS should be placed 1" from the fold line and approximately 2" from the corners.
Bead
Lower edge
1.
A
NAIL
(12 used in this step)
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
www.sauder.com/services
P
F
1N
4.
67G
1S
Off set edge
67G
C
N
Lower edge
2.
419958
3.
67G
P
B
Off set edge
Bead
Page 21
Publicidad
