Special Safety Instructions - Würth 5707 010 Serie Traducción Del Manual De Instrucciones De Servicio Original

Safety Warnings Common for
Grinding, Sanding, Wire Brushing,
and Abrasive Cutting-Off Operations:
Application
This electric tool is to be used as a
a)
grinder, sander, wire brush and cut-
instructions, precautions, illustrations
and data supplied with the device. Failure
to observe the following instructions can result in
This electric tool is not suitable for
b)
polishing. Uses for which the electric tool is not
Do not use any accessories not
c)
for this electric tool. Just because the acces-
The permissible speed of the accessory
d)
used must be at least as high as the
maximum speed indicated on the electric
tool.
Outside diameter and thickness of
e)
the accessory used must conform to
Accessories with inserted thread must
f)
of the electric tool. With accessories
boring.
a loss of control.
16

Special safety instructions

Do not use damaged accessories.
g)
Before every use, inspect accessories
such as grinding wheels for splintering
and cracks, grinding discs for cracks or
severe wear and wire brushes for loose
or broken wires. If the electric tool or
accessory falls down, check whether
it is damaged or use an undamaged
accessory. When you have inspected
and other persons in the vicinity outside
the plane of the rotating accessory and
allow the device to run at maximum
speed for one minute.
Wear personal protective equipment.
h)
Depending on the application, use a
full face mask, eyeshield or protective
goggles. If appropriate, wear a dust
mask, hearing protection, protective
gloves or a special apron that protects
you from small grinding and material
particles.
Ensure that other persons stay a safe
i)
distance away from your working
area. Everyone entering the working
area must wear personal protective
equipment.
Hold the device only at the insulated
j)
handles when carrying out work where
the attachment could contact concealed
electricity cables or the mains lead of
the electric tool.
-