Special Safety Instructions - Würth EWS 10-125 COMPACT Traducción Del Manual De Instrucciones De Servicio Original

Safety Warnings Common for Grind-
ing, Sanding, Wire Brushing or Abra-
sive Cutting-Off Operations:
Use
This power tool is intended to function
a)
as a grinder, sander, wire brush or
cut-off tool. Read all safety warnings,
instructions, illustrations and specifica-
tions provided with this power tool.
Failure to follow all the instructions may result in
electric shock, fire and/or serious injury.
Operations such as polishing are not
b)
recommended to be performed with
this power tool. Operations for which the
power tool was not designed may create a
hazard and cause personal injury.
Do not use accessories which are not
c)
specifically designed and recommend-
ed by the tool manufacturer. Just because
the accessory can be attached to your power
tool, it does not assure safe operation.
The rated speed of the accessory must
d)
be at least equal to the maximum
speed marked on the power tool. Acces-
sories running faster than their rated speed can
break and fly apart.
The outside diameter and the thickness
e)
of your accessory must be within the
capacity rating of your power tool. Incor-
rectly sized accessories cannot be adequately
guarded or controlled.
Threaded mounting of accessories must
f)
match the grinder spindle thread. For
accessories mounted by flanges, the ar-
bour hole of the accessory must fit the
locating diameter of the flange. Acces-
sories that do not match the mounting hardware
of the power tool will run out of balance, vibrate
excessively and may cause loss of control.
16

Special safety instructions

g)
Before each use, inspect accessories
such as abrasive wheels for chips and
cracks, backing pad for cracks, tear or
excess wear, wire brush for loose or
cracked wires. If a power tool or acces-
sory is dropped, check it for damage or
install an undamaged accessory. After
inspecting and installing an accessory,
position yourself and bystanders away
from the plane of the rotating accesso-
ry and run the power tool at maximum
no-load speed for one minute. Damaged
accessories will normally break apart during this
test time.
h)
Depending on application, use a face
shield, safety goggles or safety glass-
es. As appropriate, wear dust mask,
hearing protectors, gloves and work-
shop apron capable of stopping small
abrasive or workpiece fragments. The
eye protection must be capable of stopping flying
debris generated by various operations. The dust
mask or respirator must be capable of filtering
particles generated by your operation. Prolonged
exposure to high intensity noise may cause
hearing loss.
Keep bystanders a safe distance away
i)
from work area. Anyone entering the
work area must wear personal protec-
tive equipment. Fragments of workpiece or
of a broken accessory may fly away and cause
injury beyond immediate area of operation.
Hold power tool by insulated gripping
j)
surfaces only, when performing an
operation where the cutting accessory
may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool
"live" and shock the operator.
k)
accessory. If you lose control, the cord may be
cut or snagged and your hand or arm may be
pulled into the spinning accessory.
Never lay the power tool down until the
l)
accessory has come to a complete stop.
The spinning accessory may grip the surface and
pull the power tool out of your control.
Do not use a damaged accessory.
Wear personal protective equipment.
Position the cord clear of the spinning